选择配置：

当前选择：B-CUBE Pixhawk PX4 PIX PRO 32 Bit Flight Controller Autopilot with PM02 V3.2 Power Module (12S) Quadcopter Ardupilot

默认

PRO PDB

PIXHAWK PRO

B-CUBE Pixhawk PX4 PIX PRO 32 Bit Flight Controller Autopilot with PM02 V3.2 Power Module (12S) Quadcopter Ardupilot

产品名称 B-CUBE Pixhawk PX4 PIX PRO 32 Bit Flight Controller Autopilot with PM02 V3.2 Power Module (12S) Quadcopter Ardupilot

产品分类 PIXHAWK PRO

产品编号 #000293

更新时间 2026-09-18

立即咨询联系我们

产品详情

The product has passed strict CE certification. If you need a PDF or more complete test certificate, please leave a message.

PIXHAWK PRO

Features:

Pixhawk PRO support the latest official ardupilot firmware and PX4 firmware.

1. The advanced 32-bit ARM CortexM4 high-performance processors(2MB flash), can run NuttX RTOS real-time operating system;

2. 14 PWM / servo output;

3. Bus interface (UART, I2C, SPI, CAN);

4. The integrated backup power and backup controller fails, the primary controller fails over to the backup control is safe;

5. Provide automatic and manual modes;

6. Provide redundant power input and failover;

7. Multicolor LED lights;

8. Provide multi-tone buzzer Interface

9. Micro SD recording flight data;

10.TYPE-C USB port

11.GH1.25 port

Specifications:

Interface

1.5 high voltage compatible UART 1, 2 with hardware flow control

2. 2 CAN

3.Spektrum DSM / DSM2 / DSM-X satellite receiver compatible input

4.Futaba SBUS compatible inputs and outputs

5.PPM Signal Input

6.RSSI (PWM or voltage) Input

7.I2C

8.SPI

9.3.3 and 6.6VADC input

10. External MICRO USB Interface

Package include:

PIXHAWK PRO x1

Safety Button And Buzzer X1

3Line (4P GH1.25, 6P GH1.25, 2.54Pin )

PM02 V3.2 Power Module (12S) For PIXHAWK 6C 2.4.8 PX4 Ardupilot

PM02 V3.2 PDB Power Module
Description:

This PM02 Power Module provides a simple way to supply regulated 5.2V to flight controller from the battery while providing current consumption and battery voltage measurements via analog signal through a 6 Pin JST-GH cable. It comes with pre-soldered wires, capacitor, and XT60 connector on both ends, along with shrink tubing on the PCBA for physical protection.

Specification:

Input Voltage: 2S-12S

PCB Cont. Current Rating: 60A

PCB Burst Current Rating: 100A (<60 Sec)

Max Current Sensing: 120A

Output: DC 5.2V & 3A Max

Voltage Divider: 18.182

Amperes per Volt: 36.364

Weight: 20g

Please Note:

The XT60 Plug and 12AWG wire that are pre-soldered on the board is rating for 30A continuous current and 60A burst current (< 60 Seconds). If a higher current is being used, the plug type and wire size should be changed accordingly. You can refer to this chart for reference.