RemoteID
RemoteID For PIXHAWK2.4.8: Used for Pixhawk2.4.8 Flight Control
RemoteID For PIXHAWK PRO: Used for Pixhawk PRO Flight Control
RemoteID For PIXHAWK 6C: Used for Pixhawk 6C Flight Control
Send as you select.
How to use RemoteID for ardupilot firmware?
Use for ardupilot, you should compile the code,
git clone --recurse-submodules https://github.com/ArduPilot/ardupilot.git
cd ardupilot
./waf configure --board FMUV3 --enable-opendroneid #FMUV3 is pixhawk2.4.8 and pixhawk PRO board, you can change other
./waf copter
To solve this problem, I have compiled the code, which you can download here,https://www.uavbb.com/firmware/remoteid/
How to use RemoteID for PX4 firmware?
please read here,
https://docs.px4.io/main/en/peripherals/remote_id.html
Overview
RemoteID Module is a low-cost, small-size, and light-weight module that broadcasts information about UAVs in flight through WiFi and Bluetooth. It supports both CAN and serial protocols. It is a FCC and CE-approved radio module.
The products run open-source firmware (ArduRemoteID) and provides a so-called standard Remote ID solution, primarily target drone manufacturers & system integrators.
Note: This product is designed for the Standard Remote ID Solution, primarily targeting drone manufacturers and system integrators, as you need to do your own approval process at the FAA (DoC submission) if you are in the USA. For the most accurate and latest information related to this topic, please refer to the official governance website of your country.
Specification
Radio module:
Espressif ESP-C3 module
Bluetooth and WiFi 2.4GHz (ERP): + 20 dBm (100 mW)
FCC & CE certified radio module
Firmware:
ArduRemoteID (https://github.com/ArduPilot/ArduRemoteID).
Supports upgrading firmware via the web interface (“OTA”)
Supported in PX4 & Ardupilot
Protocol: CAN & Serial
Interface:
1x JST GH 4-pin CAN (CAN) port
1x JST GH 6-pin TELEM (UART) port
Antenna Connector type:
On PCB: IPEX Connector
Range: > 5km detection range*
Power: 5V supplied from TELEM or CAN port
LED lights: Bright RGB status LED
Size:
35.3 x 23.5 mm (not including antenna)
Mount: M2 screws
Operating temperature: -40°C to +85°C
Weight:
PCB only: 4 g
With Antenna: 16.5g
The detection range depends on many factors such as the receiver antenna gain, transmission protocol, weather conditions, flying height, receiver height line of sight etc. With professional receivers a range of 5 km and more is possible.
